Composite Tension Insulator related products FNB4-1 / 70 * FNB4-6 / 70 * FNB4-10 / 40 * FNB4-10 / 70 * FNB4-10 / 100 * FNB4-15 / 70 * FNB4-20 / 70 * FNB4- 20/100 * FNB4-24 / 70 * FNB4-24 / 100 * FNB4-28 / 70 * FNB4-33 / 70 * FNB4-35 / 70 * FNB4-15 / 100 * Composite Tension Insulator Insulator is a special concept insulation control can play an important role in the overhead power transmission lines. Early years insulator used for poles, slowly developed in the high-pressure end of the wire connecting the tower to hang a lot of disk-shaped insulator, it is to increase the creepage distance, usually made of glass or ceramic, called insulators. Insulator should not change because of various electrical and mechanical stress caused by environmental and electrical load conditions and failure occurs, or insulator will not have a significant effect, it will damage the use and operation of the entire line of life. Composite Tension Insulator detailing insulation composite rod suspension insulator sheath thickness ≥5MM, uniform thickness, in line with the national standard IEC standards. Umbrella skirt and jacket with the overall molding technology. End seal high pressure high temperature vulcanized rubber seal technology to achieve the four protection purposes, to enable reliable performance with end seal. Connection fittings crimp using international advanced technology. Umbrella skirt designed with unique aerodynamics. ERC temperature using enhanced acid mandrel. Unique gold with slotted design, and consistent thickness slotted eliminate point discharge. Fittings galvanized layer using rare earth aluminum hot-dip galvanizing technology, to avoid crimping the zinc layer off. Products imported raw materials, which hydrophobic HC1 level can reach the level.